Thingiverse
9mm Speedloader
von Sdhilks
335
Downloads
261
Likes
1
Makes
Speedloader designed from a Ruger P-95 magazine. Should work with most magazines, but measure the width of yours before printing and scale up if necessary (inside clearance is 21x32mm at 100% scale.)
Put a spring from a pen in-between the parts when you assemble.
**Important: Print the trigger part laying down to strengthen the bending parts. If printed vertically, there is a high chance of breakage at a layer line. Print this part at 100% infill.
Put a spring from a pen in-between the parts when you assemble.
**Important: Print the trigger part laying down to strengthen the bending parts. If printed vertically, there is a high chance of breakage at a layer line. Print this part at 100% infill.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
