MakerWorld
Engineering
Zum Modell
A/C Drainage Clamp
16
Downloads
8
Likes
0
Makes
Hello! I made a small clamp to hold my drainage hose from my mini split. I printed it with PETG since its sitting outside. For me, its to let the water flow easier out of the hose. It's not used for holding real tight but really just to hold it in a certain position. No pressure or too heavy of a drainage hose. Takes about 15 minutes to print out so its never a waste to try if itll work for you.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
