A-Com Case Battery Contact

This case is designed to hold an A-com made from an Arduino Nano.
The necessary resistors have been soldered onto the front of the board while the positive and ground contacts have been soldered onto the back side.

Alphacom logo designed by Ben/Katsu

I used battery contacts from novelty finger lights. I trimmed and bent the contacts into the shape I wanted and then drilled a small hole in the end of the contacts to allow the through-hole resistors to fit through both the Arduino and the contacts so the solder can form a really solid connection.

To learn more about the A-Com visit http://alphahub.site/guide