Thingiverse
A Light In The Darkness
von tc_fea
3
Downloads
5
Likes
0
Makes
This is a lithophane of the Statue of Liberty, a light in the darkness of the world.
My son took this picture while kayaking in New York. Used with his permission.
Printing recommendations:
1. Print at 0.1 mm layer height for maximum gray shading.
2. Use 100% infill to avoid showing the infill and for correct shading.
3. Use white plastic. Clear or natural color plastic did not work well for me.
I used white PLA.
This print took about 8 hours to print on a MakerGear M3-ID
My son took this picture while kayaking in New York. Used with his permission.
Printing recommendations:
1. Print at 0.1 mm layer height for maximum gray shading.
2. Use 100% infill to avoid showing the infill and for correct shading.
3. Use white plastic. Clear or natural color plastic did not work well for me.
I used white PLA.
This print took about 8 hours to print on a MakerGear M3-ID
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
