A Liner / A Frame Trailer

Model based on the A Liner Scout, but looks pretty similar to any A-Frame without dormers! The print in the pictures was a quick print on an Anycubic Kobra Neo, so I apologize for the poor print quality- I printed another on the P2S to confirm my print profile works, but apparently deleted the picture and tossed the model before I got around to uploading. So yours should come out looking much better than that! I've included a profile for both one color and multicolor; the multicolor will cost a lot of waste and print time, so I strongly suggest hand-painting if you don't have a multi-head printer. There are a lot of supports on this bad boy, but they should pop off decently well under the current settings. Using a support filament interface leaves the bottom as smooth as a first layer and I recommend using that if possible! If you want to print with no supports, drop the model below the build plate to allow the ‘frame’ to sit as your first layer, but note that the jacks and half of the