Thingiverse
A simple pin stand
von marcos971
0
Downloads
2
Likes
0
Makes
A simple pin stand for 3 3.7mm pins with only 6.60g of filament (measured on orca sliser)
Dimensions:
Length: 103 mm
Width: 30 mm
Height: 25 mm
Printing parameters:
Materials at your discretion, PLA works very well in this case i used Sunlu Pla meta
If you like it, offer me a coffee ;) :
paypal.me/marcos971v
Dimensions:
Length: 103 mm
Width: 30 mm
Height: 25 mm
Printing parameters:
Materials at your discretion, PLA works very well in this case i used Sunlu Pla meta
If you like it, offer me a coffee ;) :
paypal.me/marcos971v
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
