Thingiverse
A Small Vase
von bathrobotics
69
Downloads
43
Likes
2
Makes
A Small Vase (approx 94mm high)
Print, make sure its water tight, then enjoy.
The Base is thicker as shown in the X-Sec.
DOWNLOAD THE THICKER VASE; ITS BETTER(!)
this is printed with two layer walls. (I left the thinner file on here in case anyone preferrs to print like that).
there is a ring in the bottom to hold flowers in position.
To keep a flower central, print off two small support rings:
http://www.thingiverse.com/thing:685632
Download, Print, Enjoy.
Bath Robotics,
aka Eur Ing Andy Southern
Print, make sure its water tight, then enjoy.
The Base is thicker as shown in the X-Sec.
DOWNLOAD THE THICKER VASE; ITS BETTER(!)
this is printed with two layer walls. (I left the thinner file on here in case anyone preferrs to print like that).
there is a ring in the bottom to hold flowers in position.
To keep a flower central, print off two small support rings:
http://www.thingiverse.com/thing:685632
Download, Print, Enjoy.
Bath Robotics,
aka Eur Ing Andy Southern
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
