Thingiverse
A TOPIARY (3D models)
by joeyshanks
1
Downloads
2
Likes
0
Makes
Mostly everything was printed at low resolution with .02 PLA.
Drop me a line if you have any questions.
The FLOWERS print better with supports but not necessary.
Also, if you are trying to print a FUNNEL stack to fit on a 1 liter bottle, print at 80% size.
If you are printing the PETALS to fit inside the FUNNEL slots, I would make them 1-2mm thinner in your slicer. You will have better luck getting them to fit in the slots.
Drop me a line if you have any questions.
The FLOWERS print better with supports but not necessary.
Also, if you are trying to print a FUNNEL stack to fit on a 1 liter bottle, print at 80% size.
If you are printing the PETALS to fit inside the FUNNEL slots, I would make them 1-2mm thinner in your slicer. You will have better luck getting them to fit in the slots.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!