MakerWorld
Decor
Go to Model
A working shelf.
7
Downloads
12
Likes
4
Makes
It's just a working shelf that you can 3D print and it works amazing, only requires 4 screws/pins to go in the wall, or just 2 pins/screws. And just glue the top parts. It takes only 186g. In total of the 2 prints.Boost MePlease, it took some time to design. 1 Hour!If you notice the support angles holding the board on top, that is so it can support the shelf top. You may glue it. It still doesn't require it but I recommend it. Or drill a hole and screw it in. Through the tiny square.Boost MeAgain, please boost, it took 1 hour to design this.Boost MeIt helps a lot!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
