A1 / A1 Mini Fan Relocation Mod

BOM: 1x 5015 Fan with PWM and TachI purchased this one:https://www.fabreeko.com/products/5015-blower-fan-by-honeybadger?_pos=1&_sid=01ff5c452&_ss=r&variant=44775115587839 Make sure to select 4 wire PWM/Tach 2x M4x20mm Screws (I found some on amazon) Recommended:JST-XH 2.54 Crimp tool and connectors/terminal pack (amazon)I struggled to depin the orignal connector, so I just cut and terminated a new one. I've attached a picture of the correct wiring pinoutDO NOT PLUG IN THE FAN WITHOUT REWIRING FIRST. SMOKEY FAN , may cause damage to toolhead board and fan. Instructions:I printed the upper fan housing and back cover in PLA+I recommend to use a filament that has a high glass transition such as ABS/ASA/NYLON..etc for the lower fan. It's actively cooled so it shouldn't give you too much problem with melting if you were to print in PLA+. I have not tested it in PLA however. Perhaps try PETG if you want to be on the safe side and don't have the means to do ABS.Remove the front