A1 HSW System V2

This is the somewhat anticipated V2 of the A1 HSW system! V2 features several upgrades:1. The corner bracket is tougher, with a rear wall on the exterior and back mounting plates of the bracket to handle the load of all the gadgets you are going to hang from them.2. The corner bracket now has some help! The side bracket and top bracket add just the little extra bit of stability you need to keep your honeycomb from wobbling during printing. Print an extra side bracket if desired to add even more support!3. The corner and side brackets now feature a back mounting panel for a double line of HSW honeycomb! This makes it feel just a little bit more like traditional HSW so you don't feel left out. AssemblyAssembly is basically the same as for the V1 HSW. Just slide the brackets onto the A1 as pictured and then wiggle the honeycomb lines into place. A dab of hot glue is all it takes to make the installation of the honeycomb lines permanent. Just be careful not to get glue inside the hexag