A1 Lead Screw Support

These are included with my original riser feet page here as of 01-23 but I'm unsure of the best way to reach the people that have downloaded them so here it is separately. Gantry stabilizers that go underneath the lead screws per request from @loafer_coyote0b. Thanks again!I printed without supports since its a small gap to bridge, but the hard rubber pad on the underside of the gantry should slot into it, purge bins that sit up close to the printer shouldn't have any issues. It really does help with support since the bed is set down on the gantry then attached with screws from beneath, a major oversight on the original design on my part. I do not use bambu studio so I have not uploaded a print profile, only the raw files and a presorted plate. If someone would be so kind as to take on that task it would be very much appreciated. Print 2x of A1ScrewStablizerBody in a material of your choice.Print 2x of A1ScrewStablizerPad in TPU.