A1 Mini Extended Spool Holder

A1 Mini Extended Spool HolderDescription:This is a replacement part for the a1 mini spool holder. It is longer than the original, allowing for spools up to 76mm wide to fit on the A1 Mini Spool Holder. I designed it to work with my Prusa to Bambu Spool adapter (check out my profil to see it), but works with other spools to. Assembly:To install the part, you will need to first remove the original holder from the A1 mini. You than separate the two parts by pushing in the clip that can be found where the two parts meet, and pulling them apart(see picture with red circle) Tan you simply push in the new part (it's a nice, tight fit)Printing:-0.2mm layer hight-Takes a bit over 2 hours to print -no supports needed-PETG recommended for durability but not necessary