A1 Mini LED Light Mod

I did a little LED light Add-on for the A1 Mini. I used two 12V LED strips in serial connection and a tuya led controller. 24v power comes from the ams, which is a molex microfit plug. for the tuya led controller is the uploaded housing. you can push the molex connector in the opening of the lid, the file as a tight fit. this way, the whole controller is mounted on the side of the printer. i routed the cable through the sleeve of the other cables, going to the z motor housing. there you can exit an stick the led strips to the x arm. see full instructions on my blog: https://daniel-strohbach.de/diy-bambulab-a1-mini-light-upgrade EDIT: I added a 5mm spacer card, as the fitting on the molex got loose over time. just place the spacer from above over the molex connector and everything is good :)To remove the box, push the spacer card up, then tilt the box so the snap hook is visible and then push it to release the molex connector.