A1 mini Light Bar & Pi Camera Module Mount

NOTE: THIS MODEL REQUIRES A VARIETY OF SCREW & HEAT-SET INSERTS TO WORK. PLEASE CHECK OTHER PARTS NEEDED BEFORE PRINTING! This is my current A1 mini lighting setup with a Pi Camera Module 3 to monitor the prints. You can find LED stripes easily on Amazon or AliExpress. Mine is a 190mm*10mm one, connect to A1 mini's AMS connector. The LED strip heats up a lot during use, so using PETG for the parts that hold the LED strip is highly recommended!The light diffuser is optional; I laser cut it with 2mm transparent-white acrylic board. The 3D model is also included for reference.I use the Pi Camera Module 3; other versions have NOT been tested! Currently, I don’t have much time to make a full assembly guide, but you can read the notes in the other parts section for assembly instructions. I will add an guide if many of you request it or when I have some free time to do so. ;) Known issues:The light bar might bend a little after use, but it does not affect its functionality. It has been te