MakerWorld
3D Printer Accessories
Zum Modell
A1 Mini Spool Holder
117
Downloads
26
Likes
66
Makes
A1 Mini Spool HolderproblemThis simple spool holder solves the problem of the stock A1 Mini holder being too small and causing the spool to tilt. good designIt doesn't use bearings, which can cause noise, but the spool can still spin freely on the holder itself.The design is adjustable, ensuring your spool stays in place.With just over an hour of printing time, it's a quick and effective upgrade. InstallationUse a little force and slowly twist it over the stock spool holder.Boost MeIf you find this spool holder helpful and think it improves the A1 Mini setup, a boost would mean a lot to support future designs and updates – thank you!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
