A1 series integrated led light

Hi everyone!I needed to light up the bed of my A1 printer and all the models available were bulky and required external wiring.I managed to install some led strip under the x axis of my printer, powering them thru the stock wiring already installed.You can do the same choosing one of the following ways (an easy one and an hard one that allow you to power the light on and off thru the printer touchscreen).The default print profile is for a led strip 38cm long divided in 2 pieces, if you need different length use the parametric design placing the endcap end/or the cablecap if needed and based on your wires dimensions. Keep in mind that I'm not responsible for any problem that you may cause to your printer following this tutorial. For the easy one you only need a 24V led strip (not wider than 12mm) and some wires.Unplug your printer from the power cableRemove the bottom base of your A1/A1 mini printer (to do so follow the steps from 3 to 5 on this page https://wiki.bambulab.com/en/a1/