Thingiverse
A30M geeetech double blower duct
door mattjames1980
7
Downloads
10
Likes
0
Makes
still working on this and currently printing 2nd fix model...hope it works!
will switch to PETG and 0.12LH once signed off
no supports needed
2 of the stock bolts will be too long if wanting to use plus cannot get two bolts in (one each side)
need 4 more M2.5 x 6mm bolts to put in 6 holes....cannot access 2 of them, 1 either side....
printed 0.2 LH 20% infill.......seems to work well...might print with PETG at a later date but seems far enough from nozzle not to melt yet
will switch to PETG and 0.12LH once signed off
no supports needed
2 of the stock bolts will be too long if wanting to use plus cannot get two bolts in (one each side)
need 4 more M2.5 x 6mm bolts to put in 6 holes....cannot access 2 of them, 1 either side....
printed 0.2 LH 20% infill.......seems to work well...might print with PETG at a later date but seems far enough from nozzle not to melt yet
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!