Thingiverse
A50 phone case stand replacement
von dehotjava
0
Downloads
0
Likes
0
Makes
Replacement case stand for A50 phone model
Latest version: 3
how I installed:
1. put the metal pin in the hole to connect both pieces
2. sweep the part at an angle into the upper case slides with the upper part
3. to install the bottom part (has feet that touch the table), put one of the nubs in its case groove and then push the other side nub down into its groove
how I printed:
top/bottom pattern: lines, bottom pattern initial layer: lines
top/bottom line directions: [0]
combing: not in skin
support: zig zag, infill line direction: [45], support density: 50%, placement: touching build plate
build plate adhesion type: brim, width: 8mm
Latest version: 3
how I installed:
1. put the metal pin in the hole to connect both pieces
2. sweep the part at an angle into the upper case slides with the upper part
3. to install the bottom part (has feet that touch the table), put one of the nubs in its case groove and then push the other side nub down into its groove
how I printed:
top/bottom pattern: lines, bottom pattern initial layer: lines
top/bottom line directions: [0]
combing: not in skin
support: zig zag, infill line direction: [45], support density: 50%, placement: touching build plate
build plate adhesion type: brim, width: 8mm
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!