Thingiverse
A8 Power Switch Bracket
door Conroymp
2
Downloads
3
Likes
0
Makes
Switch mounts below the power supply on the clone A8 printers. It uses 2 holes already in the power supply and hardware left over from the Kit. Measure your switch and adjust the hole accordingly.
Switch is wired in line with the red power wire. This way you can plug the printer in, but wait to power it on until voltages have stabilized. Less shock on the electronics that way.
Switch is wired in line with the red power wire. This way you can plug the printer in, but wait to power it on until voltages have stabilized. Less shock on the electronics that way.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!