Thingiverse
Electronics
Go to Model
AA Battery Holder
127
Downloads
80
Likes
0
Makes
A simple, low profile AA battery holders.
I used battery clips that have a long edge that I use in my projects to bend them a bit so I can solder them to a PCB board. Specifically designed to have a very low profile to save space (battery will touch the bottom of the PCB).
You also have an easy way from the sides to pull the battery out for replacement.
The battery clips I used are standard ones. These are 12mm x 12mm without it's connection foot. A sample can be seen here: https://www.amazon.com/uxcell-Pairs-Silver-Battery-Spring/dp/B00GN3PN46/
You can find the corresponding AAA Battery Holder here: https://www.thingiverse.com/thing:3117089
I used PETG for this, just because it is more elastic and less brittle. Plus the fact that it is also more heat resistant (when soldering). However, This will work just fine with PLA.
I used battery clips that have a long edge that I use in my projects to bend them a bit so I can solder them to a PCB board. Specifically designed to have a very low profile to save space (battery will touch the bottom of the PCB).
You also have an easy way from the sides to pull the battery out for replacement.
The battery clips I used are standard ones. These are 12mm x 12mm without it's connection foot. A sample can be seen here: https://www.amazon.com/uxcell-Pairs-Silver-Battery-Spring/dp/B00GN3PN46/
You can find the corresponding AAA Battery Holder here: https://www.thingiverse.com/thing:3117089
I used PETG for this, just because it is more elastic and less brittle. Plus the fact that it is also more heat resistant (when soldering). However, This will work just fine with PLA.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
