Thingiverse
AA Battery Holder
von Gene4fun
4
Downloads
1
Likes
0
Makes
Yet another AA Battery Holder. Shorter Profile than most, also it has designed
reverse voltage protection, by not allowing contact if Battery is installed backwards.
I use double backed foam tape to mount this holder, as you must insulate the bottom from any metal surfaces that might short the Battery.
To make this holder, you will need 25mm Long x 2.5mm to 3mm Wide Solar Tabbing wire. You can use 5mm Battery weld strips or 5mm Solar tabbing wire, but you need to cut it down the center. ( Note: The solar tabbing wire solders much easier )
DO NOT USE YOUR WIFE'S GOOD SCISSORS TO CUT THEM or you are bound to get your Ass kicked ( or so I'm told ). Electricians Scissors work well.
The Negative end is the flex end, I start from the bottom with a curve on the tip, thread it through, make a 90 degree on the bottom of the strip so I don't pull it through and have to start again. Fold it back, insert in the top slot, and work it through, sometimes the tip of a razo
reverse voltage protection, by not allowing contact if Battery is installed backwards.
I use double backed foam tape to mount this holder, as you must insulate the bottom from any metal surfaces that might short the Battery.
To make this holder, you will need 25mm Long x 2.5mm to 3mm Wide Solar Tabbing wire. You can use 5mm Battery weld strips or 5mm Solar tabbing wire, but you need to cut it down the center. ( Note: The solar tabbing wire solders much easier )
DO NOT USE YOUR WIFE'S GOOD SCISSORS TO CUT THEM or you are bound to get your Ass kicked ( or so I'm told ). Electricians Scissors work well.
The Negative end is the flex end, I start from the bottom with a curve on the tip, thread it through, make a 90 degree on the bottom of the strip so I don't pull it through and have to start again. Fold it back, insert in the top slot, and work it through, sometimes the tip of a razo
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
