AA Battery Holder

Cap and body that holds 19 AA batteries: the cap/body have notches that keep the cap relatively secure and recesses to allow pulling the cap off. The design is also stackable with a chamfer and hex in both the body and lid that hold together fairly well. The cap and body have text labels for easy reading (on all six sides of the body).

Tested prints at .3mm and 15% infill - this is a fairly strong design that doesn't require a massive amount of support material (Prusa slicer saying about 15% of the material used with snug style but otherwise default Prusa slicer settings). At Prusa slicer default settings for .3mm draft this is about 4.16 cubic inches (1115 linear inches) of filament and takes about 5.5 hours to print.

Dimensions: 2.87" wide (flat to flat across the hex) x 2.64" tall when assembled.

AA Battery Holder © 2025 by Paleflame is licensed under CC BY-NC-SA 4.0