Thingiverse
aaa battery dispenser
door alanerickson
53
Downloads
54
Likes
0
Makes
I wanted an aaa dispenser to go along with the original one, but I didn't just want to scale it due to the fact that all of the wall thicknesses, pins, and holes would get thinned down. So while this is listed as a remix, a large part of this was redrawn / re-extruded so that the dimensions of the previously mentioned items could remain the same as the original.
No support needed, although you may need to rotate the model to get the correct orientation. Seems to work as well if not slightly better than the original, meaning that batteries do occasionally hang up and the thing needs to be tapped to get the batteries moving. I printed in pla, although abs or petg would be just fine.
Edit. Two other items. The dispenser holds 15 batteries. You should lower the minimum travel distance for retraction to 2mm or lower to prevent stringing in the cover open webbing.
No support needed, although you may need to rotate the model to get the correct orientation. Seems to work as well if not slightly better than the original, meaning that batteries do occasionally hang up and the thing needs to be tapped to get the batteries moving. I printed in pla, although abs or petg would be just fine.
Edit. Two other items. The dispenser holds 15 batteries. You should lower the minimum travel distance for retraction to 2mm or lower to prevent stringing in the cover open webbing.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!