AAP-01C Mock Suppressor

A mock suppressor for the AAP-01C. Used to make the gun look better and also to help hide longer barrels. To install, simply remove the 2 M3 screws from the lower rail (1). Pull out the rubber insert from the front of the pistol and put to one side (2). This will not be needed again. Take the printed suppressor and push it into the front of the pistol, making sure that the flat spot lines up with the flat in the body of the pistol (3). Using the 2 M3 screws that were removed earlier, bolt the suppressor to the AAP-01C (4). NOTE: The 2 holes in the printed suppressor will need to be tapped to M3 before trying to install it. If you don't own an M3 tap, you can very carefully tap the holes by using an M3 bolt and a lighter. By heating up the bolt with the flame you can then screw the bolt into the 3D print and it will melt a thread into the part.