Thingiverse
AAP01 holster for TTI trigger
door Mul13r
106
Downloads
159
Likes
0
Makes
This is a Holster for AAP-01 with TTI trigger setup.
Hardware required:
2 M3x10 screws
4 M3x8 screws
4 M3 nuts
1 6mm diameter spring
Standard holster belt attachment (I used IMI Defense)
Note: This holster will work only if your trigger is set to a very short pull.
Hardware required:
2 M3x10 screws
4 M3x8 screws
4 M3 nuts
1 6mm diameter spring
Standard holster belt attachment (I used IMI Defense)
Note: This holster will work only if your trigger is set to a very short pull.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
