Abdeckung_R2 Split

I found the part "Abdeckung_R2" to use way too much supports, so I split the part into two to reduce both the amount of supports needed and also greatly reducing the print time.

the two parts can be quite tricky to line up perfectly but should be ok if you use a wide tape to align them.
I glued the parts together with two-part epoxy,
After it dried I sanded down the part to get rid of any bumps due to the glue, and then spray painted it.

Please refer to the original part "Abdeckung_R2" to see how the parts fit together.

I hope you will find this file useful.