Thingiverse
Ableton Push 2 stand
par QuintusO
83
Téléchargements
56
Likes
2
Makes
This is a stand designed for the Ableton Push 2 controller. It fits many other controllers and even laptops as well.
It was designed to fit sideways on the bed of an Ender 5. Printing the model on its side gives better strength and, in my opinion, a better finish.
The stand allows for a 20 degrees viewing angle. It's very rigid and can probably carry more than 10kg of weight.
Required parts:
- 8 x M3 16mm or 20mm DIN 912 bolts.
16mm bolts will be fully recessed in the stand. 20mm will stick out as shown in the photos.
It was designed to fit sideways on the bed of an Ender 5. Printing the model on its side gives better strength and, in my opinion, a better finish.
The stand allows for a 20 degrees viewing angle. It's very rigid and can probably carry more than 10kg of weight.
Required parts:
- 8 x M3 16mm or 20mm DIN 912 bolts.
16mm bolts will be fully recessed in the stand. 20mm will stick out as shown in the photos.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
