MakerWorld
Hueforge & Lithophane
Ver Modelo
Abstract 2
2
Descargas
3
Likes
1
Makes
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 200x200mm in size. You can change X and Y but Z must remain the same.You may print at higher layer heights below the Min Depth of 0.48mmActual Depth is 2.2mm Filaments Used:PLA BambuLab Basic Black Transmission Distance: 0.3PLA BambuLab Basic Jade White Transmission Distance: 5PLA BambuLab Basic Red Transmission Distance: 4PLA BambuLab Basic Orange Transmission Distance: 7PLA BambuLab Basic Yellow Transmission Distance: 6This print uses 5 unique filaments. Substitute as needed. Swap Instructions:Start with BlackAt layer #8 (0.72mm) swap to Jade WhiteAt layer #13 (1.12mm) swap to RedAt layer #20 (1.68mm) swap to OrangeAt layer #23 (1.92mm) swap to YellowAt layer #25 (2.08mm) swap to Jade White for the rest. Boost MeGot a Boost to spare? Every little bit helps the motivation. Thank you!MembershipWant to go commercial or maybe just show some love? Consider signing up to show support!
Corp también publica en
338 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!