Ac vent extender v2

This is better design from v1 , to print this product u must rotate this object vertically stand if not overhangs cause the ugly connection (spaghetti) clipper will not work , however at that side has flaw on 75mm connector may look bad on inner layer, thank you hope you enjoy this product

To use this product
1. Print your type either 300mm short type or 450mm long type and 3 clippers for each part A and B
2. To be assembled 3 clippers are pushed in its holder near the cut part is the entrance
3. Each part a and b will be slide in
4. With the teeth of clipper you can attach to its ac wing