Thingiverse
ACA500 VGA Bezel
von Elrond022
0
Downloads
2
Likes
0
Makes
This is a VGA Bezel for the clear case of Plexilaser for the ACA500 (Plus). It's made for the back of the case because I was annoyed of the cable clutter in the back of the A500.
It's very tight fitting, so perhaps you need to sand it a little bit.
It's very tight fitting, so perhaps you need to sand it a little bit.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
