Slicer Discord
Accessory Friendly Deck Box – 3D-printbaar model van MakerWorld MakerWorld
Board Games

Accessory Friendly Deck Box

191 Downloads
87 Likes
128 Makes
Model downloaden
I'm sure a lot of Pokémon TGC players use sleeves and accesories they get from Elite Trainer Boxes; I know I do. And I like to carry around all the accessory kit: health marker die, coin dice, status indicators, etc. I made this box specifically to fit a full deck of 60 cards with ETB card sleeves on (with enough give for maybe a few extra backup cards), and a tray for the accessories so they don't just slide around over the cards. The smaller compartment in the accessory tray is the perfect size to hold two full sets of ETB die (as pictured), and the other compartment is roomy enough for even the oversized coins they give with some themed decks… It also has a handy tab to pull it out of the box. The lid is attached via a simple hinge that allows it to open to about a 100 degree angle; which might seem strange but I like that it stays up like that. It's also adorned with a very subtle pokeball design (you can color that if you want, but I don't have a way to). It may be
Categorie
Board Games
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie