Thingiverse
Accessory Holder Box
door pxlsmn
11
Downloads
11
Likes
0
Makes
Designed for my Office. It has 12 subjects that are 4.8cm wide and 6.5 cm high. The whole thing has a length of 20cm, a height of 24 at the highest point and a width of 14.5 cm. The box has a 25 degree angle.
Printing:
You need to adjust it a little in the Slicer, you have to lay the thing on the backside and turn it to the right or left, because its very big.
Printet in 0.30mm DRAFT mode.
Printing:
You need to adjust it a little in the Slicer, you have to lay the thing on the backside and turn it to the right or left, because its very big.
Printet in 0.30mm DRAFT mode.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
