ACE Angler v4

*Please follow me on Instagram at @bedriddendesign :)* This is the fourth version of the ACE Pro Angler. The Angler is a workaround for many false errors that cause prints to pause in the middle of a job. Applicable notes: This design removes possible interferences with the filament spools. The design is asymmetric, so refer to the reference photo for which angler goes where. Slot 1 and 3 are the same, Slot 2 and 4 are the same. The print profile prints all 4 at the same time. I like having a snug fit to the ACE Pro cover, so there will be a slight interference there. Please remix this design if you prefer otherwise. This is ONLY if you want to use a Bowden Tube in the middle to make the Angler last longer. This diameter has not been tested without a Bowden Tube. Bowden Tube dimensions: 2mm ID x 4mm OD x 50mm minimum length (55mm max). Indicator light hole was added in v3. Change descriptions between versions: V1 = Initial Release V2 = Increase strength, remove issue with getting pulled out during retraction. V3 = Increase lifetime by adding Bowden tube in the middle. Also added indicator light pass through. V4 = Increase clearance from spools to remove possible interference.