Thingiverse
Learning
Model downloaden
Acoustic Levitator test dish
16
Downloads
18
Likes
0
Makes
An alternate design for a mounting a transducer on a 8020 series 10 extrusion. This design is focused at approximately 89mm. A pair of them are used to create a version of the MiniLev found in Asier Marzo's instructable:
http://www.instructables.com/id/Acoustic-Levitator/
The holes are sized for 1/4 - 20 screws. The design requires two 8020 T-nuts and screws.
The transducer removal tool is a plug that will allow the transducer to be pushed back out of the mount.
The companion electronics platform can be found at:
https://www.thingiverse.com/thing:3183438
The original bracket can be found at:
https://www.thingiverse.com/thing:3168253
http://www.instructables.com/id/Acoustic-Levitator/
The holes are sized for 1/4 - 20 screws. The design requires two 8020 T-nuts and screws.
The transducer removal tool is a plug that will allow the transducer to be pushed back out of the mount.
The companion electronics platform can be found at:
https://www.thingiverse.com/thing:3183438
The original bracket can be found at:
https://www.thingiverse.com/thing:3168253
NotLikeALeafOnTheWind publiceert ook op
252 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
