Thingiverse
Acrow prop Vive lighthouse mounting system
por PhobosIndustries
14
Descargas
15
Likes
0
Makes
This is a non destructive acrow prop based mounting system for the HTC Vice lighthouses. I wanted a method to quickly set up and take down the lighthouses without having to install fixings in different environments. My design is a remix of the great idea by cmooney91 (https://www.thingiverse.com/thing:1793515). I liked the wedge based quick change system, and wanted to incorporate it into my prop design.
The basic idea is that pressure is applied between the floor and ceiling to hold the fixture in place. The props use a telescopic design, where the excess of the upper stage is kept inside the lower stage. This allows for a use with various ceiling heights. The pipe is just standard PVC electrical conduit, 25mm and 20mm, each cut to a length of 1800mm.
The floor foot (25mm) has a 10mm thick rubber pad screwed to the bottom. The rubber is drilled and tapped to accept M3 machine screws from the top, so that only the rubber makes contact with the floor. Similarly the ceiling foot (2
The basic idea is that pressure is applied between the floor and ceiling to hold the fixture in place. The props use a telescopic design, where the excess of the upper stage is kept inside the lower stage. This allows for a use with various ceiling heights. The pipe is just standard PVC electrical conduit, 25mm and 20mm, each cut to a length of 1800mm.
The floor foot (25mm) has a 10mm thick rubber pad screwed to the bottom. The rubber is drilled and tapped to accept M3 machine screws from the top, so that only the rubber makes contact with the floor. Similarly the ceiling foot (2
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!