Acrylic Case for ThingOMatic (TOM)

I'm not a big fan of the wood case for the TOM and I wanted to make one out of Acrylic. I found the very nice case that BuiltToSpec did ( http://www.thingiverse.com/thing:11641 ) but I wanted a case built on the latest case design. BuiltToSpec's was based on the older case which had the side mounted fan, I wasn't sure what other changes had been implemented in the latest design, and I was pretty sure I would have to make a good deal of adjustments to support my actual Acrylic thickness. So I just started with the latest official TOM case drawings. I did use BuiltToSpec's idea to stress relieve the corners of the nut slots though - kudo's for that thought!

Anyway, the attached drawings were modified to work with the 1/4 Inch Acrylic I could source. I waited until the Acrylic actually arrived and then measured its thickness. As others will attest, the thickness of 1/4 inch Acrylic can vary a lot between manufacturers and I even saw a pretty good variation in one corner of the si