Thingiverse
Action button for iPhone 15 Pro PopSocket MagSafe case
door gothi
0
Downloads
0
Likes
0
Makes
PopSocket's iPhone 15 Pro MagSafe cases launched with a badly placed gap where there should have been an Action button. This makes using the iPhone's Action button very difficult, so here's the missing button to add to your case.
The button features a long thin strip to keep it in place, this should overlap the ‘volume up’ button slightly and has not shown to interfere with its operation on my print. You can of course trim this if preferred, but this design was the result of many tests on how to keep the button in place and still be usable.
The button is lower profile than the 2 volume buttons allowing easy distinction between button types but raised enough for ease of use.
I have only printed this with TPU, other filaments may be too stiff and perform sub-optimally.
The button features a long thin strip to keep it in place, this should overlap the ‘volume up’ button slightly and has not shown to interfere with its operation on my print. You can of course trim this if preferred, but this design was the result of many tests on how to keep the button in place and still be usable.
The button is lower profile than the 2 volume buttons allowing easy distinction between button types but raised enough for ease of use.
I have only printed this with TPU, other filaments may be too stiff and perform sub-optimally.
gothi publiceert ook op
3 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
