Thingiverse
Action Camera HO Scale Car
von Zippercdrr
1
Downloads
4
Likes
0
Makes
New! 33mm-34.5mm
Had a friend expand the gap for my dads GoPro Hero 11 Black.
The Hero 11 is 27mm, but a 28mm print fit it. My friend sent over files in half steps from 27mm to 28.5mm.
It has been noted that some trimming to the front was needed due to the wide angle the 11 can film at by my dad, who is filming a neighbors set up. The end corners where snipped off with some flush cuts.
Had a friend expand the gap for my dads GoPro Hero 11 Black.
The Hero 11 is 27mm, but a 28mm print fit it. My friend sent over files in half steps from 27mm to 28.5mm.
It has been noted that some trimming to the front was needed due to the wide angle the 11 can film at by my dad, who is filming a neighbors set up. The end corners where snipped off with some flush cuts.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!