Thingiverse
Action Figure Stand
von jgohlke
2
Downloads
4
Likes
0
Makes
Each stand comes with two sizes each that cover multiple types of 3.75 inch action figures.
I wanted a relatively small base with a "disappearing borer", so they slope down. This led to difficulty getting them off the base, so I added a little notch at the bottom.
I wanted a relatively small base with a "disappearing borer", so they slope down. This led to difficulty getting them off the base, so I added a little notch at the bottom.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!