Slicer Discord
Action Park Light Box – 3D printable model from MakerWorld MakerWorld
Signs & Logos

Action Park Light Box

0 Downloads
0 Likes
0 Makes
Go to Model
8 color lightbox, requires two AMS units. Action Park, New Jersey. “Sure, people died… but it was amazing!” If there's interest I'll make an alternate version that says "But did you die?". My apologies to the families that were impacted. For everyone else, the documentary was pretty good. Sits on a flat surface or hang on the wall using #7 screws and mollies. Install the COB LED light strip to the inside perimeter. Apply hot glue to help keep the tape light in place. Add aluminum foil (duct) tape (if desired) to help distribute the light. I used E6000 to adhere the lid to the base. The purple I used had to high of a transmission value, so I made the purple of the model thicker to compensate.
Category
Signs & Logos
Source
MakerWorld
Published
Updated
What you need to print this: Advanced Low confidence
Why?
8 colors · significant post-processing
Single piece 8 colors / AMS Hardware needed
Supports 1/3
Assembly 0/3
Settings 3/3
Bed size 0/3
Post-process 2/3
Printer
FDM / FFF
File format
STL
Material
PLA
Colors
8 (AMS/MMU recommended)
Post-processing
Gluing, Hardware
Software
Cura, PrusaSlicer, or similar
Same designer, more platforms

MattInDetroit also publishes on

36 additional models across 3 more platforms

Verified by matching model titles across platforms.
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection