Active 2.0 mount for wall mount

It does not appear that active no longer sells the foot accessory for the 2.0 pressure washer. It appears that it comes standard with the 2.0 now. I have the old 2.0 with the rubber feet.

I printed this with Bambu Labs TPU for AMS. This seems to have the right amount of softness. You have to remove the old rubber feet and use the screws to mount these new TPU mounts.
I used 4 walls along with 25% infill.

The holes are designed for quarter-inch bolts. I did use fender washers on both sides. I also use lock nuts to keep things tight with the vibration. Do not over tighten.

1/4x1 hex bolts (4)
1/4 fender washers (8)
1/4 lock nuts (4)