Thingiverse
Acty Shifter Boot Delete
door JDMGems
8
Downloads
6
Likes
0
Makes
I was tired of having the sifter boot feet break off causing the shifter to flop around while driving so I created a block off plate for the shifter boot. Enjoy
The "plate" needs to be printed in TPU and when installed rotated clockwise about 5 degrees to avoid binding shifting from second to third.
The bezel (the larger part) should be made from ABS, ASA, PETG, or PC. I would strongly advise against PLA due to the low heat tolerance.
When putting this together install the plate first
Then, when installing the bezel slip in the tab closes to the radio in first then click in the side and lower tab in by applying pressure.
I added a Fushion360 file if you'd like to remix this somehow.
Instagram : JDM_GEMS_IMPORTS
The "plate" needs to be printed in TPU and when installed rotated clockwise about 5 degrees to avoid binding shifting from second to third.
The bezel (the larger part) should be made from ABS, ASA, PETG, or PC. I would strongly advise against PLA due to the low heat tolerance.
When putting this together install the plate first
Then, when installing the bezel slip in the tab closes to the radio in first then click in the side and lower tab in by applying pressure.
I added a Fushion360 file if you'd like to remix this somehow.
Instagram : JDM_GEMS_IMPORTS
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!