Thingiverse
AD-S15 Bulb Protector
von blndcat
43
Downloads
28
Likes
1
Makes
I created a clone of the Godox AD-S15 bare bulb protector.
Printed with 0.2 layer heights, infill of 12% in PLA. Supports not needed. See screenshot where the part is in green for orientation for printing.
It isn't an exact clone as there isn't a L shaped lock but the friction knob holds it in place without any problems.
The AD-S15 isn't expensive, but this printed version is about 50¢ in plastic.
Printed with 0.2 layer heights, infill of 12% in PLA. Supports not needed. See screenshot where the part is in green for orientation for printing.
It isn't an exact clone as there isn't a L shaped lock but the friction knob holds it in place without any problems.
The AD-S15 isn't expensive, but this printed version is about 50¢ in plastic.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!