Thingiverse
ADAMnet Drive Emulator Case
door charlesmouse
15
Downloads
16
Likes
0
Makes
ADAMnet Drive Emulator Case
Update:
23.3.19 - I've done a bit of a re-work of my take on a case for this wonderful device. The intention is to make it easier and faster to print while also making assembly more straightforward. As a bonus the design has been tidied up a bit and allows for parts to be printed in different filaments for a more "authentic" look without the need for painting. I also separated out the power switch so a real one could be mounted it you wish.
I suggest printing the .stl files as oriented with support set to everywhere. For most parts 15% and GRID would be a good choice for support. But for the Ends.stl file I would strongly suggest setting the support to 10% and lines (if using CURA) as other settings might make digging out said support a bit tricky.
The wonderful Sean Myers has welded an LCD panel to an Arduino Mega, done the hard work of writing the software, and come up with a Floppy drive emulator for the COLECO ADAM...
...not only is this an a
Update:
23.3.19 - I've done a bit of a re-work of my take on a case for this wonderful device. The intention is to make it easier and faster to print while also making assembly more straightforward. As a bonus the design has been tidied up a bit and allows for parts to be printed in different filaments for a more "authentic" look without the need for painting. I also separated out the power switch so a real one could be mounted it you wish.
I suggest printing the .stl files as oriented with support set to everywhere. For most parts 15% and GRID would be a good choice for support. But for the Ends.stl file I would strongly suggest setting the support to 10% and lines (if using CURA) as other settings might make digging out said support a bit tricky.
The wonderful Sean Myers has welded an LCD panel to an Arduino Mega, done the hard work of writing the software, and come up with a Floppy drive emulator for the COLECO ADAM...
...not only is this an a
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
