Adaptec AEC-82885T Vertical Base

This is a base for the Adaptec AEC-82885T HBA Expansion card. My computer case does not have an good place for these cards to live so I made them a base to hold them upright.

There are to versions, 1X holds a single card and the 2X holds two cards as shown below. There is a 4M hole that is used to anchor the card or cards into the base. an addition 4M screw and 4 nuts are used to support the tops of the cards to increase rigidity.

The design makes room for the 4 pin molex connector but it blocks the first SFF-8643.