Add light for Delta / Kossel 3D printer

https://www.youtube.com/watch?v=JIw5MaWI3rM

Full tutorial can be found here: http://makerholik.com/3d-printing/light-up-your-3d-printer/

I decided to add LED for my Kossel 3d printer (My model is Anycubic Kossel Linear Plus) to make it easier for me to check if I need to print overnight.

Material:
6x LED stripes (12VDC, width: 1cm, length: 15cm each)
M3x10mm bolts and M3 T-nuts
Wires

Printed parts:
6x Part01
6x Part02
6x Part02_Mirror

I already show to you guys how to make it step by step in each picture. Just follow them and you can make it.

Here are all those steps:
Step 01: Using 12V LED stripe (1cm in width) and cut to 6 pieces (15cm each)
Step 02: Soldering all 6 LED stripes.
Step 03: Wire out all LED stripes.
Step 04: Make a small board to attach all LED stripes, 12VDC power supply and ON/OFF switch
Step 05: Connect and test all LED stripes.
Step 06: Using a piece of thick tape to cover all circuit board.
Step 07: Using M3 bolts and M3 T-nuts for th