Thingiverse
Adimlab Gantry Z Stepper Bracket
door jonbourg
1
Downloads
3
Likes
0
Makes
An additional mount for the Z motors on the Adimlab Gantry printer.
Hardware:
2 M3 x 12 screws for the motor
2 M4 x 8 screws to mount on the 2020 extrusion
2 M4 t-nuts
Install
Put M3 screws in
Put on motor and start M3 screws
Push t-nuts into the extrusion and align with hole
Carefully install M4 screw and get started in t-nut
Tighten all screws, but be careful not to overtighten
Hardware:
2 M3 x 12 screws for the motor
2 M4 x 8 screws to mount on the 2020 extrusion
2 M4 t-nuts
Install
Put M3 screws in
Put on motor and start M3 screws
Push t-nuts into the extrusion and align with hole
Carefully install M4 screw and get started in t-nut
Tighten all screws, but be careful not to overtighten
jonbourg publiceert ook op
5 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!