Thingiverse
Adimlab Pro BMG & E3D V6 Setup
von jonbourg
4
Downloads
3
Likes
0
Makes
This is a BMG extruder and E3D V6 hotend mount for the Adimlab Pro printer. This uses the backplate that comes with the printer so there is no modification needed there.
If you want to add this mod to an Adimlab Printer with linear rails than see this thing https://www.thingiverse.com/thing:4367312
This includes only the main mounting bracket and the strain relief. The rest of the parts and instructions can be found at the following link for the Adimlab Printer here: https://www.thingiverse.com/thing:4314318
UPDATE: 3/26/2021 Increased the size of the holes in the air duct to allow an M3 hexhead screw to go through. This will make mounting the extruder much easier.
UPDATE: 3/3/2021 Fit testing has been completed.
UPDATE: 3/2/2021 Repositioned mounting holes. The first version did not fit.
If you want to add this mod to an Adimlab Printer with linear rails than see this thing https://www.thingiverse.com/thing:4367312
This includes only the main mounting bracket and the strain relief. The rest of the parts and instructions can be found at the following link for the Adimlab Printer here: https://www.thingiverse.com/thing:4314318
UPDATE: 3/26/2021 Increased the size of the holes in the air duct to allow an M3 hexhead screw to go through. This will make mounting the extruder much easier.
UPDATE: 3/3/2021 Fit testing has been completed.
UPDATE: 3/2/2021 Repositioned mounting holes. The first version did not fit.
jonbourg veröffentlicht auch auf
5 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
