Thingiverse
Adjustable 3D Printer Feet
von mparker03
39
Downloads
24
Likes
0
Makes
Adjustable 3d printer feet.
Fit 4040 rails.
10mm height range.
40 x 40 x ~18-28mm
Printed on a stock Voxelab Aquila. Clearance on the threads is .275mm. I needed to work the threads together a little to get smooth operation but they adjust smoothly after working them. Wait until they are fully cooled.
Flat feet so you can attach padding/damper to the bottom.
The rear body was designed to fit with the power source in place on my printer. The short nub is 23mm in length.
I used double sided tape on the top face to stick them to the rails.
Fit 4040 rails.
10mm height range.
40 x 40 x ~18-28mm
Printed on a stock Voxelab Aquila. Clearance on the threads is .275mm. I needed to work the threads together a little to get smooth operation but they adjust smoothly after working them. Wait until they are fully cooled.
Flat feet so you can attach padding/damper to the bottom.
The rear body was designed to fit with the power source in place on my printer. The short nub is 23mm in length.
I used double sided tape on the top face to stick them to the rails.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
